This is a draft document that was built and uploaded automatically. It may document beta software and be incomplete or even incorrect. Use this document at your own risk.

Jump to contentJump to page navigation: previous page [access key p]/next page [access key n]
Virtualization Guide / Hypervisor-independent features / QEMU guest agent
Applies to SUSE Linux Enterprise Server 15 SP7

22 QEMU guest agent

  

The QEMU guest agent (GA) runs inside the VM Guest and allows the VM Host Server to run commands in the guest operating system via libvirt. It supports many functions—for example, getting details about guest file systems, freezing and thawing file systems, or suspending or rebooting a guest.

QEMU GA is included in the qemu-guest-agent package and is installed, configured and activated by default on KVM virtual machines.

QEMU GA is installed in Xen virtual machines, but it is not activated by default. Although it is possible to use QEMU GA with Xen virtual machines, there is no integration with libvirt as described below for KVM virtual machines. To use QEMU GA with Xen, a channel device must be added to the VM Guest configuration. The channel device includes a Unix domain socket path on the VM Host Server for communicating with QEMU GA. 

<channel type='unix'>
  <source mode='bind' path='/example/path'/>
  <target type='xen' name='org.qemu.guest_agent.0'/>
</channel>

22.1 Running QEMU GA commands

  

QEMU GA includes many built-in commands that do not have direct libvirt counterparts. Refer to Section 22.4, “More information” to find the complete list. You can run all the QEMU GA commands by using libvirt's general purpose command qemu-agent-command: 

virsh qemu-agent-command DOMAIN_NAME '{"execute":"QEMU_GA_COMMAND"}'

For example: 

> sudo virsh qemu-agent-command sle15sp2 '{"execute":"guest-info"}' --pretty
{
"return": {
  "version": "4.2.0",
  "supported_commands": [
    {
      "enabled": true,
      "name": "guest-get-osinfo",
      "success-response": true
    },
[...]

22.2 virsh commands that require QEMU GA

  

Several virsh commands require QEMU GA for their functionality. For example, the following ones:

virsh guestinfo

Prints information about the guest from the guest's point of view.

virsh guestvcpus

Queries or changes the state of virtual CPUs from the guest's point of view.

virsh set-user-password

Sets the password for a user account in the guest.

virsh domfsinfo

Shows a list of mounted file systems within the running domain.

virsh dompmsuspend

Suspends a running guest.

22.3 Enhancing libvirt commands

  

If QEMU GA is enabled inside the guest, several virsh subcommands have enhanced functionality when run in the agent mode. The following list includes only certain examples of them. For a complete list, see the virsh man page and search for the agent string.

virsh shutdown --mode agent and virsh reboot --mode agent

This method of shutting down or rebooting leaves the guest clean for its next run, similar to the ACPI method.

virsh domfsfreeze and virsh domfsthaw

Instructs the guest to make its file system quiescent—to flush all I/O operations in the cache and leave volumes in a consistent state, so that no checks are needed when they are remounted.

virsh setvcpus --guest

Changes the number of CPUs assigned to a guest.

virsh domifaddr --source agent

Queries the QEMU GA for the guest's IP address.

virsh vcpucount --guest

Prints information about the virtual CPU counts from the perspective of the guest.

22.4 More information